Entering Global System Data - Globl-Systm; Selecting The Globl-Systm Units; Selecting The System Units - GE AquaTrans AT868 User Manual

September 2004
Entering Global System
Data - GLOBL-SYSTM
Selecting the GLOBL-
SYSTM Units
Selecting the System
Units
2-22
While completing these instructions, refer to Figure A-2 in
Appendix A, Menu Maps. Remember to record all programmed data
in Appendix C, Data Records.
Use the steps below to enter system information in the GLOBL menu.
1. Press [ESC], [ENTER], [ESC]. The meter enters the user program.
2. Press [ ] until PROG appears and press [ENTER].
3. Press [ ] until GLOBL appears and press [ENTER].
4. Press [ ] until SYSTM appears and press [ENTER].
5. Enter a short message up to 16 characters by using the arrow keys.
]
Press [ and [ ] to move the cursor to desired location and
[ ] and [ ]
press to select the desired letter/space/symbol and
press [ENTER].
1. Press [ ] to select the system units and press [ENTER].
For single-channel units, go to step 6 on page 2-23. For 2-channel/
path units, proceed with the following steps.
2. Press [ ] to select the volumetric units for the flow rate display
and press [ENTER].
3. Press [ ] to select the number of digits to the right of the decimal
point in the volumetric flow rate display and press [ENTER].
4. Press [ ] to select the desired units for the totalized flow rate
display and press [ENTER].
5. Press [ ] to select the desired number of digits to the right of the
decimal point in the totalized flow rate display and press [ENTER].
Programming Site Data