Resetting Totals; Resetting Totalizers Using The Internal Keypad; Resetting Totalizers Using Panaview; Resetting Totalizers Using The External Switch - GE AquaTrans AT868 User Manual

Resetting Totals

Resetting Totalizers Using
the Internal Keypad
Resetting Totalizers Using
PanaView™
Resetting Totalizers Using
the External Switch
Displaying Data
To reset the totals, you can use the internal keypad, PanaView™ or an
external switch. When resetting totals, the totals for both channels
will be reset. Use the appropriate section that follows to reset
totalizers.
Refer to Figure A-4 on page A-4 in Appendix A, Menu Maps.
1. Press [ESC], [ENTER], [ESC]. The meter enters the user program.
2. Press [ ] until RESET appears and press [ENTER].
3. Press [ ] to select YES or NO and press [ENTER].
If you select YES, the AT868 resets the totals for both channels. If you
select NO, the totals continue.
4. To leave the User Program, press [ESC].
Refer to Figure F-4 on page F-4 in Appendix F, PanaView™ for
IDM-Combatible Meters.
1. Open the System menu.
2. Select Clear Instrument Totalizers.
3. PanaView™ automatically clears the totalizers and exits the
System menu.
While the meter is operating, press and hold the reset switch for 1
second. Totals will reset to zero and immediately begin to accumulate
again.
Note: The external totalizer reset switch must be configured as
described on page 2-23.
September 2004
3-3