Selecting Mass Flow Units - GE AquaTrans AT868 User Manual

September 2004

Selecting Mass Flow Units

Procedure Options
2-24
]
1. Press [
and [ ] to select the desired mass flow units for the
flow rate display and press [ENTER]. The available units for this
prompt are determined by the selection made at SYSTEM UNITS on
the previous page.
]
2. Press [
and [ ] to select the desired time units for the mass
flow rate display and press [ENTER].
]
3. Press [
and [ ] to select the desired number of digits to the
right of the decimal point in the mass flow rate display and press
[ENTER].
]
4. Press [
and [ ] to select the desired units for the totalized mass
flow rate display and press [ENTER]. The available units for this
prompt are determined by the selection made at SYSTEM UNITS on
the previous page.
]
5. Press [
and [ ] to select the desired number of digits to the
right of the decimal point in the totalized mass flow rate display
and press [ENTER].
After completing the above steps, the meter returns to the Global
PROGRAM window. Do one of the following:
•
You have completed entering "quick startup" data. You can
continue programming or exit the user program as described
below.
•
To continue regular programming, refer to Appendix A, Menu
Maps, to navigate to the desired menu.
To leave the user program, press [ESC] three times.
•
Programming Site Data