Upnp - Honeywell Performance Series User Manual

54 | Performance Series 5 MP Fisheye IP Camera User Guide
Parameter
Interval
Health Mail
Update Period
(interval)
Email Test

UPnP

UPnP lets you establish the mapping relationship between the LAN and the public network. In
the UPnP configuration interface, you can add, modify, or remove a UPnP item.
Enabling UPnP in Windows
When UPnP is enabled in Windows, the camera can be detected automatically through My
Network Places.
www.honeywell.com/security
Table 5-10 SMTP (Email) Configurations (cont'd)
Function
The delay interval for sending the email ranges from 0 to 3600 seconds.
0 seconds means that there is no delay interval.
The system will not immediately send the email when the alarm occurs.
When an alarm, motion detection, or abnormality occurs to activate an
email, the system sends the email according to the interval that you
have specified here. This reduces the load on the email server when
numerous emails are triggered simultaneously.
Select the check box to enable the health email function.
This allows the system to send a test email to check the connection.
Select the check box to enable this function, and then set the
corresponding email interval.
You can set the Update Period so that the system sends out regularly
scheduled emails.
The system will automatically send an email to test the connection.
Before you can send an email test, you must save the email setup
information.
Figure 5-16 UPnP Configuration Interface
Note UPnP is enabled by default on Windows 7 systems. This procedure applies to
Windows XP.