Fisheye Installation And Display Mode Configuration - Honeywell Performance Series User Manual

24 | Performance Series 5 MP Fisheye IP Camera User Guide

Fisheye Installation and Display Mode Configuration

The 5 MP Fisheye IP Cameras support a variety of installation and display modes to suit many
different surveillance requirements. See
www.honeywell.com/security
Figure 3-9 Live View Window Configuration Toolbar
Table 3-3 Live View Window Configuration Tools
Image Control
Original Size
Full Screen
Width and
Height Ratio
Adjust Fluency
Fisheye Controls
Figure 3-10 Fisheye Installation Modes and Corresponding Display Modes
Ceiling Mount
Click to open the Image Adjustment panel. Drag the sliders
to set brightness, contrast, hue, and saturation, or click reset
to return to the default settings.
Alternatively, you can go to Setup
to adjust these settings.
Note Image adjustments apply only to video displayed with
the web client interface.
Click to return video display to its original size (the size will
depend on the resolution setting of the bit stream).
Click to enter full-screen mode. Press Esc or double-click the
mouse to exit full screen.
Click to return the video display to the original aspect ratio (or
an aspect ratio suitable for the window).
Click to select a fluency level based on your network
connection. The default setting is Normal. If your network
connection is slow, you can select Fluent to make the video
appear smoother (however, this may result in a decrease in
image quality).
Click to open the Fisheye Installation and Display mode
panel. Use these controls to change the type of display
generated by the fisheye camera. See
Display Mode Configuration on page 24
Wall Mount
 
Camera Conditions
Fisheye Installation and
for more information.
Table Mount