Pppoe - Honeywell Performance Series User Manual

Parameter
RTSP Port
HTTPs
HTTPs Port

PPPoE

1.
2.
3.
Table 5-7 Connection Configurations (cont'd)
Function
The default setting is 554. The RTSP stream query format is:
Main stream:
rtsp://username:password@ip:port/cam/realmonitor?ch
annel=1&subtype=0
Sub stream:
rtsp://username:password@ip:port/cam/realmonitor?ch
annel=1&subtype=1
You are required to manually enter the following four items: Username,
Password, IP, and Port.
IP: The camera's IP address.
Port: The default is 554. You can leave this field blank if you are using
the default value.
Follow standard RTP protocols. When the encode mode is MJPEG, the
maximum supported resolution is 2040×2040.
Enable the HTTPs port.
The default is 443.
Figure 5-11 PPPoE Configuration Interface
Enter the PPPoE Username and Password that you received from the Internet Service
Provider (ISP), and enable the PPPoE function.
Click to Save the current setup, and then reboot the camera to activate the PPPoE setup.
The camera connects to the Internet via PPPoE after rebooting.
Find the IP address in the WAN from the IP address column.
Note When PPPoE is enabled, disable UPnP so that it does not interfere with PPPoE.
Configuring Camera Settings | 49
800-22756 - B - 04/2017