Ip Filter - Honeywell Performance Series User Manual

Using Honeywell DDNS to Configure DDNS
Set the DDNS to connect to the Honeywell DDNS server so that you can access the system
through the servers.
Parameter
Server Type
Server Address
Mode
Domain Name
Username

IP Filter

Enable the IP filter function so that only the specified IP/MAC addresses can access the network
camera. You can specify an IP address or an IP address segment (for example, from
192.168.1.1 to 192.168.1.100). If you do not check the box to enable Trusted Sites, there will
be no access limitation for the camera.
Figure 5-13 Using Honeywell DDNS to Configure DDNS
Table 5-9 Honeywell DDNS Configurations
Function
You can select the DDNS protocol from the drop-down list, and then
enable the DDNS function. Select the Honeywell DDNS server (which
is free) to enable the DDNS function.
This is the DDNS server IP address. Under Honeywell DDNS, the
default server address is www.hennvr-ddns.com.
Select Auto or Manual. The default is Auto. If you select Manual, then
you must enter a domain name.
Auto and self-defined domain names are both MAC
address.hennvr-ddns.com. You can define the prefix.
The user name you enter to log in the server (optional).
Configuring Camera Settings | 51
800-22756 - B - 04/2017