Installing Hot Spare Hard Drive; To Insert The Hot Spare Hard Drive; Installing Pcic Card In Dell T320 Server Using Magma; To Insert The Magma Pcie Card - Honeywell T320 Planning, Installation And Service Manual

Chapter 5 - Servicing
5.7

Installing hot spare hard drive

You can insert the hot spare hard drive when the server in on.
5.7.1

To insert the hot spare hard drive

1. From the front end of the server, locate the blocking plate at the fifth bay (marked as 4).
2. Press the latches located at the ends of the blocking plate and pull the blocking plate.
3. Remove the blocking plate.
4. Insert the hot spare hard drive in the fifth bay, that is bay marked as 4 >, from where the blocking
plate was removed.
5. Press the bracket on the hard drive such that it is locked in the fifth bay.
The hot spare hard drive is installed in the server.
5.8

Installing PCIC card in Dell T320 server using Magma

The Magma PCIe host card is located in the PCIe slot 3.
5.8.1

To insert the Magma PCIe card

1. Shut down the computer.
2. Remove the power cords from the rear end of the server and wait for 20 seconds.
3. Remove the front bezel. Refer to the section
4. Remove the side cover of the server. Refer to the section
5. Locate the slot 3.
NOTE
In Dell PowerEdge T320 Performance server Server 146 GB Hard disk drives (MZ-
PCEH02) are obsolete and Customer may receive Replacement as 300 GB (MZ-
PCEH07) Hard disk drives. These drives can be used in RAID5 array with 146 GB Hard
disk drives. Usable capacity of will remain 146 GB as it will be part of Array.
In case of multiple hard disk drives failure replacements, you need to replace the spare
hard disk drives one by one that is, after rebuilding RAID volume by 50% or more.
Removing the front bezel.
Removing the side
- 58 -
cover.