4. The rear retaining bracket is located in a slot in the rear of the slide tray. Position the front surface of
the rear retaining bracket approximately 73 mm[2.9 inches] forward of the rear surface of the slide
tray.
5. Remove the plastic film release liners from the two (2) front and two (2) rear black anti-skid pads on
the slide mounting tray. This exposes a tacky surface that helps prevent the server from sliding.
6. The photo shows the MAU connector attached to the server back panel. The LCN MAU is not used
when the LCN is integrated with an ELCN.
- 36 -
Chapter 3 - Installation