Honeywell T320 Planning, Installation And Service Manual page 57

4. The DIMM memory sockets are now exposed.
5. While wearing a grounded ESD wrist strap, press the socket ejectors on the memory module socket
down to allow the memory module to be inserted into the socket.
6. Insert the memory module.
7. Align the edge of the memory module connector with the alignment key on the memory module
socket, and insert the memory module into the socket.
ATTENTION
The memory module socket has an alignment key that allows you to install the memory
module in the socket only in one way.
8. Press down the memory module with your thumbs while pulling up on the socket ejectors with your
index fingers to lock the memory module into the socket.
When the memory module is properly seated in the socket, the socket ejectors on the memory
module socket align with the socket ejectors on the other sockets that have memory modules
installed.
9. Place the shroud back into the chassis and ensure that it is placed completely inside the chassis.
10. Close the side cover.
11. Replace the server in the cabinet.
12. Connect the power cords and cables to the back panel of the server.
13. Press the Power On/Off button on the server, to turn on the power.
- 57 -
Chapter 5 - Servicing