Install Air Duct Baffles And Blank Panel Front Covers In Cabinet - Honeywell T320 Planning, Installation And Service Manual

1. Connect the video and network interface cables.
2. Connect the Honeywell AC power cords.
3. Perform any one of the following, as necessary.
l
l
l
4. Secure any loose cables, and verify that all cables have proper strain relief.
5. If necessary, refer to the section
6. To complete the installation, turn on the server.
3.4.5

Install air duct baffles and blank panel front covers in cabinet

Air duct baffles and blank panel front covers ensure that the airflow within the cabinet allows proper
cooling for the servers. The following image illustrates the air duct baffles and blank panel front covers
used in cabinet.
WARNING
AC power cords from all computing nodes mounted in a given cabinet must be distributed
across the two power entries as equally as possible. Failure to do so may result in tripping
the circuit breakers.
If you are not using Fault Tolerant Ethernet (FTE), connect the Ethernet cable to the on-board
RJ-45 connector.
If you are using an Intel dual NIC card for FTE, connect the FTE cable to the NIC card in the
expansion slot.
If you are using the on-board NICs for FTE, connect the FTE cable to the onboard RJ-45
connector.
ATTENTION
Any unused rack mount space must have an air duct baffle and blank front panel
installed.
Figure 3.1 Air Duct Baffle and Blank Panel Front Cover
Install air duct baffles and blank panel front covers in
- 38 -
Chapter 3 - Installation
cabinet.