Yamaha MO6 Owner's Manual page 47

Voice Bank
Voice Number
SCENE
SF1 SF2
F1 F2 F3
Assigns a Voice to Deletes the Voice assignment
of the selected Part.
the selected Part.
7
Play the keyboard.
The Part 1 (piano Voice) and Part 2 (flute Voice) can be
played in unison.
Next, we'll divide the keyboard into two sections—one for
each Voice.
Dividing the keyboard into separate
sections—Split
Assign the Voice of Part 1 to the lower key
8
range.
8-1
Move the cursor to Part 1.
8-2
Press a note on the keyboard while holding down
the [SF5] LIMIT H button to set the highest note
for Part 1.
Note that the dark bar (at "NOTE") for Part 1 changes as the
note range is changed.
Assign the Voice of Part 2 to the higher key
9
range.
9-1
Move the cursor to Part 2.
SF3 SF4 SF5 INFORMATION
F4 F5 F6
Part 1: Piano
Part 2: Flute
9-2
Press a note on the keyboard while holding the
[SF5] LIMIT L button down to set the lowest note
of Part 2.
Note that the dark bar (at "NOTE") for Part 2 changes as the
note range is changed.
SF 5
Note limit low
10
Play the keyboard.
Use your left hand to play piano sounds and your right
hand to play flute sounds.
Part 1: Piano
Adjusting the Part levels and storing
the Performance
Adjust the Volume settings of Parts 1 and 2 by
11
using the Control sliders.
For details, see page 52.
Store the settings as a User Performance in
12
the Performance Store mode.
For details about the Store operation, see page 66.
n
If you are editing a program and you select a different program
without storing your edited one, all the edits you've made will be
erased.
In the section above, you learned how to assign two Voices
to two different Parts. Use same procedure to assign
Voices to Parts 3 and 4, and create a full orchestral sound
or the sound of a 3- or 4-piece band—just by using a single
MO. You can also use the preset Performances as starting
points in building your own custom Voice combinations.
Performance Play mode
SF 4
Note limit High
Part 2: Flute
Owner's Manual 47