Yamaha MO6 Owner's Manual page 143

In the Performance mode
The Effect parameters in the Performance mode are set for each Performance.
[PERFORM] Performance selection
[COMMON] [F6] EFFECT [SF1] CONNECT
The Insertion connection type depends on the setting of the Voice
assigned to the selected Part.
Tone Generator
block
*1
Part 1
Part EQ *2
Chorus Ctg, Chorus Typ (Chorus Effect Category, Chorus Effect Type)
Reverb Typ (Reverb Effect Type)
Determines the effect type for Chorus.
Chorus Send, Reverb Send
Determines the level of the sound (from Insertion A or B, or the bypassed signal) that is
sent to Chorus/Reverb effect. These parameters can be set in the Performance in the
[F2] OUT/MEF display (*3).
Settings: 0 - 127
[EDIT]
Chorus Return, Reverb Return
Chorus Pan, Reverb Pan
Determines the Return level and pan position setting for the Chorus/Reverb effect.
Settings: 0 - 127, L63 (far left) - C (center) - R63 (far right)
Chorus to Reverb
Determines the Send level of the signal sent from the Chorus Effect to the Reverb
Effect.
Settings: 0 ~ 127
Reverb Send
Chorus Send
Part 1
Insertion Effect
(VCE INS)
A
B
Internal Structure (System Overview)
System effects (Reverb effect and Chorus effect)
*3
Reverb Return
Chorus Return
Master effect
[PERFORM] Performance selection
[COMMON] [F2] OUT/MEF [SF3] MEF
*1 Select the part to which the Insertion effect is applied. The
Insertion effect depends on the setting of the Voice assigned to the
selected part.
[PERFORM] Performance selection
[F6] EFFECT [SF2] INS SW
*2 [PERFORM] Performance selection
selection [F3] EQ
*3 [PERFORM] Performance selection
[F2] OUT/MEF [SF1] OUT
*4 [PERFORM] Performance selection
[F2] OUT/MEF [SF2] MEQ
[PERFORM] Performance selection
[F1] GENERAL [SF3] MEQ OFS
*4
Master EQ
Output
[EDIT]
[EDIT] [COMMON]
[EDIT] Part
[EDIT] [COMMON]
[EDIT] [COMMON]
[EDIT] [COMMON]
Owner's Manual 143