Yamaha MO6 Owner's Manual page 114

Using the MO with computer software
Press the [ENTER] button to execute the
5
settings.
Press the [STORE] button to store the settings
6
as the system settings of the Utility mode.
CAUTION
If you turn the power off without storing, the currently edited settings
will be lost.
CAUTION
Never attempt to turn off the power while an "Executing..." or "Please
keep power on" message is shown. Turning the power off in this state
may cause the system to freeze and prevent normal startup the next
time the power is turned on, as well as resulting in the loss of all user
data.
Start the software to be remote-controlled,
7
and make the MIDI settings and remote control
settings.
Set the Port setting for remote control on the software,
referring to the illustration in step 4.
Specific instructions for setting up your particular software
follow. For instructions on how to start the software, refer to
the documentation included with the software.
Cubase SX 3
1
Pull down the [Devices] menu and select [Device
Setup] to call up the "Device Setup" window.
2
Click the [+] button and add "Mackie Control."
3
Select "Mackie Control" from the popup list.
4
When setting the Port to "4," for example, in step 4 of
"Setting up for Remote Control," set the MIDI Input to
"YAMAHA USB IN 0-4" and the MIDI Output to
"YAMAHA USB OUT 0-4."
n
The functions of buttons on the Mackie Control are assigned to the
buttons of the MO, with the exception of UserA and UserB
(FootSw) which are not supported by the MO.
SONAR 4
1
Pull down the [Options] menu and select [MIDI
Devices] to call up the "MIDI Devices" window.
2
When setting the Port to "4" for example in step 4 of
"Setting up for Remote Control" add "YAMAHA USB IN
0-4" to the "Inputs" and add "YAMAHA USB OUT 0-4"
to the "Outputs."
3
Pull down the [Options] menu and select [Control
Surfaces] to call up the Control Surface window.
4
Click the "[+] button, select "Mackie Control," then set
the Input Port to "YAMAHA USB IN 0-4" and the Output
Port to "YAMAHA USB OUT 0-4" (for example, when
setting the Port to "4" in step 4 of "Setting up for
Remote Control").
114 Owner's Manual
Digital Performer 4.52
1
Pull down the [Setup] menu and select [Control Surface
Setup] to call up the "Control Surface" window.
2
Click the [+] button.
3
Select "Mackie Control" in the Driver section.
4
In the box for setting "Unit" and "MIDI," select "Mackie
Control" in the "Unit" section and select the MIDI port in
the "MIDI" section.
Logic Pro 7
When turning on the power of the MO before starting
Logic:
1
Start Logic on the computer, then turn on the power of
the MO.
2
Start Logic on the computer.
Logic automatically recognizes the MO as Logic
Control and performs the required settings.
When starting Logic before turning on the power of the
MO:
1
Start Logic on the computer, then turn the power to the
MO on.
If you have already set the software to be controlled to
"Logic" in the Utility mode, you need not perform step 2
because Logic automatically recognizes the MO when
this step is performed.
2
Set the software to be controlled to "Logic" in the Utility
mode, then enter the Remote Control mode.
Logic automatically recognizes the MO and performs
the required settings.