Yamaha MO6 Owner's Manual page 180

Song Record mode Song Record Standby mode
(Tempo)
Meas (Measure)
[F2] VOICE
In this display you can set the voice related parameters for the recording track. The settings here affect the Part for which the receive channel (set in the
Mixing mode) matches the transmit (output) channel of the recording track.
Voice
Volume
Pan
InsEF
(Insertion Effect Part Switch)
(Tempo)
Meas (Measure)
[F3] ARP (Arpeggio)
From this display you can set parameters related to the Arpeggio of the recording track.
Bank, Ctgr (Category), Type
VelLimit (Velocity Limit)
Hold
PartSw (Part Switch)
Meas (Measure)
[SF1] ARP1 (Arpeggio 1) –
[SF5] ARP5 (Arpeggio 5)
[F4] RECARP (Record Arpeggio)
RecArp (Record Arpeggio)
OutputSwitch
TransmitCh (Transmit Channel)
[F5] CLICK
Pressing the [F5] button lets you turn the click sound (metronome) on/off for recording.
[F6] ALL TR (All Track)/1TR (1 track)
Pressing the [F6] button lets you switch between Single Track recording and All Track recording.
Owner's Manual
180
Determines the Song tempo.
Settings: 001.0 – 300.0
Determines the measure from which Song recording will be started.
Determines the voice used in the recording track. When the cursor is located here, you can select a voice by
using the Bank, Group, Number buttons and the Category Search function (page 42).
Determines the volume of the recording track.
Settings: 0 – 127
Determines the stereo pan position of the recording track.
Settings: L63 (Left) – C (Center) – R63 (Right)
Determines whether the Insertion effects are applied to the recording track or not.
Settings: on, off
Determines the Song tempo.
Settings: 001.0 –300.0
Determines the measure from which Song recording will be started.
These three parameters determine the Arpeggio Type. The three-letter prefix number before the Type name
indicates the number within the selected Category.
Settings: Refer to the separate Data List.
Determines the lowest and highest velocity which can trigger the Arpeggio playback. The Arpeggio plays
when you play notes at velocities within this range.
Settings: 1 – 127
Determines whether the Arpeggio playback is "held" or not. When this is set to "on," the Arpeggio cycles
automatically, even if you release your fingers from the keys, and it continues to cycle until the next key is
pressed.
Settings: sync-off, off, on
n
About sync-off, see page 154.
Determines whether Arpeggio is on or off for the tone generator Part corresponding to the recording track.
Settings: off, on
Determines the measure from which Song recording will be started. This parameter is same as the Meas
parameter in the [F1] SETUP display.
You can register the desired Arpeggio types and Song Scenes to these buttons and call them up any time
during your keyboard performance. Refer to page 89 in the Quick Guide section.
Determines whether the sequence data played by Arpeggio is recorded to the Song track or not. When this is
set to on, the played sequence data is recorded.
Settings: off, on
Determines whether the sequence data played by Arpeggio during recording is output via MIDI or not. When
this is set to on, the played sequence data by Arpeggio during recording is output via MIDI.
Settings: off, on
Determines the MIDI transmit channel of the Arpeggio playback during recording.
Settings: 1 – 16, KbdCh