Cisco Explorer Series Staging Manual page 99

3 When the LED displays the time or [- - - -] (or, for non-LED DHCTs, blinks eight
times, pauses, and repeats), go to Check for Stranded IPPV Events (on page 89).
Check for Stranded IPPV Events
This section provides instructions for checking for stranded IPPV events for DHCTs
with and without LEDs.
Checking for Stranded IPPV Events on DHCTs with Front-Panel Alphanumeric LED Displays
This procedure is for DHCTs with front-panel alphanumeric displays. If your
DHCTs do not have front-panel alphanumeric displays, follow the procedure in
Checking for Stranded IPPV Events on DHCTs with Only POWER LED Indicators
(on page 89).
1 Activate the staging toolkit using the procedures described in Activating the
Staging Toolkit (on page 168). The LED panel on the DHCT displays the EMM
ISE count for each DHCT that has been entered into the billing system. Before
proceeding, wait for the count to stop. There should be 4 or 5 EMMs.
2 Press 4 on the remote control and the LED panel displays the PPV purchase
count in the form of P-XX.
3 Does the LED panel display P-00?

If yes, there are no stranded IPPV events. Press the Exit key on the remote.
The LED panel displays the [- - - -] Service Disconnect Mode indicator. You
are finished with this procedure.

If no, then there are stranded IPPV events in the DHCT. Go to Clearing
Stranded IPPV Events (on page 90).
Checking for Stranded IPPV Events on DHCTs with Only POWER LED Indicators
Note: This procedure is for DHCTs without front-panel LEDs. If your DHCTs have
front-panel alphanumeric LED displays, follow the procedure in Checking for
Stranded IPPV Events on DHCTs with Front-Panel Alphanumeric LED Displays (on
page 89).
1 Activate the staging toolkit using the procedures described in Activating the
Staging Toolkit (on page 168). The POWER light indicator blinks four times,
pauses, then blinks four times again. This behavior does not repeat.
2 Press 4 on the remote control. The POWER light indicator displays one of the
following behaviors:

Blinks five times quickly, pauses, then repeats. This indicates there are no
stranded IPPV events on the DHCT

Blinks five times slowly, pauses, then repeats. This indicates there are
stranded IPPV events on the DHCT
734375 Rev H
Check for Stranded IPPV Events and Clear NVM
89