Staging Cablecard Modules - Cisco Explorer Series Staging Manual

Chapter 7 How to Stage CableCARD Modules

Staging CableCARD Modules

The first step in staging CableCARD modules is to load the EMM CD (or download
the EMMs from the Cisco FTP site) and confirm that the correct CableCARD module
type exists. See Obtain and Load EMM Data (on page 53) for more information.
Does your billing system allow you to set up CableCARD modules with no billing
action?
If yes, go to Stage CableCARD Modules with No Billing Action (on page 80).

If no, go to Stage CableCARD Modules with Billing Action (on page 82).

Stage CableCARD Modules with No Billing Action
If your billing system allows you to set up CableCARD modules with no billing
action, you can stage them using the procedures in this section. If your billing
system requires a billing action when you stage CableCARD modules, you must use
the staging procedures in Stage CableCARD Modules with Billing Action (on page
82).
80 734375 Rev H