Cisco Explorer Series Staging Manual page 34

Digital home communications terminal
Table of Contents

Advertisement

Chapter 3 Optimize Your System Performance for Downloads and Staging
Field
De-Authorization Time-out Period
(days)
MaxKeySessionPeriod*
RF Output (channel)
Card Authorization Phone
Number
*MaxKeySessionPeriod is measured in decaseconds for S-Mode boxes and minutes for M-Mode boxes.
For more information see http://www.opencable.com/
SR 2.7/3.7 and 4.2 and SR 2.7/3.7/4.2 SP0.2 or SP2
Note: For detailed information about the fields within the DNCS GUI, refer to Setting
Up PowerKEY CableCARD and M-Card Modules on the DNCS for System Releases 2.7/3.7
and 4.2 (part number 4014667). Sites running SR 2.7/3.7/4.2 SPs should refer to
Setting Up PowerKEY CableCARD and M-Card Modules on the DNCS For System
Releases 2.7/3.7 and SR 4.2 Service Pack 2 (part number 4017453).
Field
IP Address of Server Running the
CCardServer Process (typically
this is the IP Address on the DNCS
that connects to the QPSKs)
Port Number
24
Recommended Value
30
Important: We recommend that you set this value to
30. If this value is too large, it could interfere with
the total number of authorization entries that can be
added to the podData file and could also interfere
with the binding of the CableCARD module/host
pairs.
10
Important: We recommend that you set this value to
10. Defining a rate less than 10 requires a large
number of unnecessary calculations on the
CableCARD module. Defining a rate greater than 20
does not coincide with best security practices.
Value is based on the site's individual preference.
Typically, if the site uses channel 3 for DHCTs, it
should also use channel 3 for CableCARD host
devices.
Phone number that subscribers should call when
they need assistance. You can enter up to 20
alphanumeric characters (including spaces) in this
field.
Recommended Value
Autobinding on: 10.253.0.1
Autobinding off: 0.0.0.0
Important: If you do not use the default IP address
for your CableCARD server, check your network
map, the /etc/hosts file for the dncsatm entry, or
with your network administrator for the correct IP
address.
Autobinding on: 13830
Autobinding off: 0
734375 Rev H

Advertisement

Table of Contents
loading

This manual is also suitable for:

Explorer 2100Explorer 3100Cablecard

Table of Contents