Table of Contents
Advertisement
Maintenance
Always leave at least one battery connected to the DL230 (to
X5 or X6) when changing batteries. This way, the DL230 will
continue to work whilst the batteries are being changed.
CAUTION!
Reduced battery power!
The simultaneous use of an old and a new battery
considerably reduces battery power.
Therefore:
– When using two batteries always exchange both at the
same time.
1
Ill.: 20
1
Ill.: 21
2
2
3
1. If the external power supply is
connected, then disconnect it.
1
2. The grey covering strips on both
the right and left-hand side of the
cover are pressed out-wards at
the small groove (Ill.: 20 1 ). This
means that the screws on the
cover become visible.
3. Loosen the four screws
(Ill.: 20 2 ) with which the
housing is connected.
4. Open the cover of the DL230 by
pushing down on it.
5. Loosen the screw on the battery
holder Ill.: 21: 1 and pull out the
mounting element for the battery 2 .
The element fits very snugly in the
guides.
6. Mark the old battery using e.g. a felt-
tipped pen or stickers.
7. Choose the free CPU Power con-
nection on the board to connect to
the new battery (Ill.: 22: X5 or X6).
8. Place the new battery onto the base
of one of the three locations
provided for it (Ill.: 21: 3 ).
77
Advertisement
Table of Contents
