Admin" Register (Administrator) - Honeywell DL230 Operating Instructions Manual

66

6.4.4 "Admin" Register (Administrator)

This register is used to display and check special device settings and
conditions. This application is provided for meter operators.
Display
3
User values
Input 1
Input 2
Input 3
Input 4
Tariff programs Sub-menu for revaluation and the corresponding
Measured
values
Archives
Status
Date and time
Batteries
Outputs
Interfaces
Device settings Sub-menu for all device settings
Identification
6.4.4.1 SReg – Status register (total)
All messages since the last manual clear are collected in the status
register. It can be seen here what e.g. has occurred since the last visit. The
reports can be (Serv.  Status  Clr) deleted from the device. Only
alarms and warnings are displayed (see Chapter 8.2) in status registers.
In the "User Values" sub-menu, the user can set up to 10 freely programma-
3
ble parameters and up to 12 freely programmable parameters in a further sub-
menu within this list.
Description
Sub-menu for user-specific parameters
Sub-menu for values and parameters for input 1
Sub-menu for values and parameters for input 2
Sub-menu for values and parameters for input 3
Sub-menu for values and parameters for input 4
parameters
Sub-menu for measured values and the corresponding
parameters
Sub-menu for existing archives in the device
Sub-menu for current status, status register and logs
Sub-menu for date, time and the corresponding
parameters
Sub-menu for the device battery and the corresponding
parameters
Sub-menu for both outputs and the corresponding
parameters
Sub-menu for existing interfaces in the device
Sub-menu for the identification of the gas system
Operation