Table of Contents
Advertisement
62
If the calibration lock is opened when the certification data
log is full, it can only be closed again after the calibration
log has been deleted.
6.3.6.3 Administrator and customer locks
Administrator and customer locks are used to protect data which is not sub-
ject to calibration regulations, but which should also not be modified without
authorization.
These locks can be opened by entering a code (i.e. the "key") under Cod.A
or Cod.C and are closed by entering "0" for St.AL or St.CL.
These values can be found under the following path:
Admin Device settings Access
Serv. Device settings Access
or
A time (in minutes) can also be set here for each lock, after which it will au-
tomatically close. AutAL, AutCL, AutPL
6.4 Data register content
6.4.1 Access rights
The "access" column in the tables in the following chapter describes which
lock must be opened in order to change a parameter. All parameter
changes are saved in a log.
Access Description
E
Calibration officer
PL
Certification Data Log
A
Administrator
K
Customer
-
No access
Operation
Advertisement
Table of Contents
