48-Port 10/100Base-T Fabric-Enabled Ethernet Switching Module (Ws-X6548-Rj-45) - Cisco Catalyst 6500 Series Installation Manual

10/100 and 10/100/1000 Ethernet Switching Modules
48-Port 10/100BASE-T Fabric-Enabled Ethernet Switching
Module (WS-X6548-RJ-45)
Figure 1-22 48-Port 10/100BASE-T Fabric-Enabled Ethernet Switching Module (WS-X6548-RJ-45)
WS-X6548
1
2
STATUS
Catalyst 6500 Series Switch Module Installation Guide
1-34
The 48-port 10/100BASE-T switching module (WS-X6548-RJ-45) provides
48 switched, 10/100-Mbps, full- or half-duplex ports. (See
have RJ-45 connectors for Category 5, 5e, and 6 cable. The WS-X6548-RJ-45
module has 1-MB per-port packet buffers and a single fabric channel interface.
The switching module is upgradable to support distributed forwarding with an
optional Distributed Forwarding Card (WS-F6K-DFC). The WS-X6548-RJ-45
module is auto-MDI/MDIX capable; you can use either straight or crossover
cable, and the module will automatically detect and adjust for the cable type.
The QoS port architecture (Rx/Tx) for this module is 1p1q0t/1p3q1t.
11 13 23 25
12 14 24 26
48 PORT 10/100 BASE-T
ETHERNET
The front panel LEDs are described in
Chapter 1
35 37 47
36 38 48
SWITCHING MODULE
Table 1-6 on page 1-47.
Product Overview
Figure 1-22.) Ports
78-15725-02