Flexwan Module (Ws-X6182-2Pa) - Cisco Catalyst 6500 Series Installation Manual

FlexWAN Module (WS-X6182-2PA)

Table 1-7 ATM Module LEDs (continued)
LED Color/State Description
LINK Green
Orange
Flashing
orange
Off
ACTIVE Green
Off
SIGNAL Green
FlexWAN Module (WS-X6182-2PA)
Catalyst 6500 Series Switch Module Installation Guide
1-52
The port is active (the link is connected and operational).
The module or port is disabled through the CLI command or the module
is initializing.
The port is faulty and has been disabled.
The port is not active or the link is not connected.
The port is active (the link is connected and operational).
The port is the standby port.
The active port is receiving a valid signal level through the fiber-optic
cable; this condition does not indicate valid framing.
The FlexWAN module (WS-X6182-2PA) is installed in a switch that has a
supervisor engine with an MSFC and a PFC. (See
conjunction with the FlexWAN module, provides multiprotocol routing support
with full Internet route connectivity for speeds ranging from serial RS-232 to
OC-3. The FlexWAN module can accept up to two Cisco 7200/7500 WAN port
adapters, which deliver WAN consolidation and extend QoS and
traffic-management capabilities over WAN segments. The FlexWAN module
supports ATM and Packet-over-SONET (POS) OC-3 links and channelized,
multichannel, and clear channel port adapters.
adapters.
Chapter 1 Product Overview
Figure 1-39.) The MSFC, in
Table 1-8 lists the supported
78-15725-02