Gigabit Interface Converters - Cisco Catalyst 6500 Series Installation Manual

Gigabit Interface Converters

Table 2-11 Catalyst 6000 Series and Catalyst 6500 Series Bandwidth and Port Density (continued)
Architecture
Number of ATM OC-12
ports
Number of FlexWAN
Modules
1. Specific combinations of supervisor engines and modules may not be supported in your chassis. Refer to the release notes
of the software version running on your system for specific information on modules and supervisor engine combinations that
are not supported.
2. If you have backplane bandwidth greater than 32 Gbps, you must install a Switch Fabric Module or install a Supervisor
Engine 720 in the Catalyst 6500 series switch chassis.
Gigabit Interface Converters
Catalyst 6500 Series Switch Module Installation Guide
2-18
Catalyst 6000 Series Switch
5 (6 slots) Catalyst 6006 switch
8 (9 slots) Catalyst 6009 switch
5 (6 slots) Catalyst 6006 switch
8 (9 slots) Catalyst 6009 switch
A Gigabit Interface Converter (GBIC) is a hot-swappable input/output device that
plugs into a supervisor engine or Gigabit Ethernet module which links the module
with the fiber-optic network or with the copper network.
This section contains these topics:
WS-G5483 Copper GBIC, page 2-19
•
WS-G5484, WS-G5486, and WS-G5487 Optical GBICs, page 2-20
•
• Coarse Wave Division Multiplexing GBICs, page 2-21
Chapter 2 Preparing for Installation
Catalyst 6500 Series Switch
2 (3 slots) Catalyst 6503 switch
5 (6 slots) Catalyst 6506 switch
8 (9 slots) Catalyst 6509 switch
12 (13 slots) Catalyst 6513 switch
2 (3 slots) Catalyst 6503 switch
5 (6 slots) Catalyst 6506 switch
8 (9 slots) Catalyst 6509 switch
12 (13 slots) Catalyst 6513 switch
1
78-15725-02