Cisco Catalyst 6500 Series Installation Manual page 146

Installing a Supervisor Engine or a Switching Module
Figure 3-3 Closing the Ejector Levers in a Horizontal Slot Chassis
WS-X6K-S UP2-2GE
1
CONSOLE
CONSOLE
SUPERVI SOR2
WS-X6K-S UP2-2GE
2
CONSOLE
CONSOLE
SUPERVI SOR2
3
4
WS-C65 00-SFM
5
SWITCH FABRIC MDL
6
Catalyst 6500 Series Switch Module Installation Guide
3-8
PORT
MODE
PCMCIA
EJECT
PORT
MODE
PCMCIA
EJECT
Ejector levers flush
with module faceplate
Vertical slots
Position the supervisor engine or switching module in the slot. (See
a.
Figure 3-4.) Make sure that you align the sides of the switching-module
carrier with the slot guides on the top and bottom of the slot.
Carefully slide the supervisor engine or module into the slot until the EMI
b.
gasket along the right edge of the module makes contact with the module in
the slot adjacent to it and both ejector levers have closed to approximately
45 degrees with respect to the module faceplate. (See
Switch Load
100%
PORT 1
PORT 2
1%
Switch Load
100%
PORT 1
PORT 2
1%
Chapter 3 Installing the Module
Figure 3-5.)
78-15725-02