Using An Rtp To Field Wiring The 8 Channel Analog Output - Honeywell ControlEdge 900 platform Hardware Planning And Installation Manual

Appendix A - Installing RTP
3. Set/verify jumper positions as shown for use with an analog output module.
4.

Using an RTP to field wiring the 8 Channel Analog Output

To wire the 8 Channel Analog Output using an RTP:
1. Mount the RTP cable assembly to ControlEdge 900 Controller. See the
214
b. Connect the cable to the RTP.
Switch SW1 is not used. Module RIUP is not affected by using the RTP.
See "RTP Cable wire positions, colors, and internal schematic" on page 1 for
more information.
Connect field wiring.
ATTENTION: RTP and cables are intended for permanent installation within
their own enclosure.
following figure for the example installation diagram.