4. Connect field wiring, as shown below.
ATTENTION: Short connect terminal 30 and 31 as shown in the diagram
above.
See "Terminal Block-to-Field (Signal) Wiring" on page 106 for more
information.
Using an RTP to field wiring the UAI
ATTENTION:
RTP is not for use with thermocouples.
l
RTP and cables are intended for permanent installation within their own
l
enclosure.
To wire the UAI using an RTP
1. Mount the RTP cable assembly to ControlEdge 900 Controller. See the
following figure for the example installation diagram.
Appendix A - Installing RTP
191