Cisco Gs7000 Super High Output Intelligent Node Installation And Operation Guide - Cisco GS7000 Installation And Operation Manual

Install Fiber Optic Cable
If using the alternate (right-side) fiber connection port, you have to route the fibers through the fiber
Note
channel in the fiber track located underneath the unused fiber holders.
5 Hold the connector body to prevent rotation of the connector or fibers.
6 Carefully thread the 5/8-inch threaded nut into the threaded hole of the fiber port. Tighten to 20 to 25 ft-lbs
(27.1 to 33.9 Nm).
7 Firmly tighten the rotational nut against the 5/8-inch threaded nut.
8 Push heat shrink tubing over the connector and fiber port and shrink in place.
9 Identify individual fibers according to their color code and determine to which receiver or transmitter
module each fiber will connect.
10 Pivot the fiber tray back down and snap it into place on top of the power supply with its locking tabs.
11 Open the fiber tray cover and carefully wind the fibers around the spool in a counterclockwise direction.
Be sure to leave enough fiber so that each connector can reach its intended module. Note that different
diameter spool paths are provided to properly adjust the fiber length.
12 Route each fiber to its intended module through the fiber track as shown.

Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide

26
Installation