Node Inputs/Outputs Diagram; Module Functional Description - Cisco GS7000 Installation And Operation Manual

Node Inputs/Outputs Diagram

Node Inputs/Outputs Diagram
The following diagram shows the system-level inputs and outputs of the node.
Port 3 and Port 6 are only for power.
Note
• The AC can be applied through any housing base port and routed, if required, to the other ports.
• The DC power supply modules can be fed by any housing base port (1 through 6).

Module Functional Description

This table briefly describes each module. See
the modules.
Module
RF Amplifier
Remote PHY
Device (iRPD)
Cisco GS7000 Super High Output Intelligent Node Installation and Operation Guide
4
Theory of Operation, on page 7
Description
The RF Amplifier Module includes:
• four forward RF output ports
• four reverse inputs
• forward and reverse bandwidths that are established by diplexer and reverse low
pass filter assembly selection
The Remote PHY Device includes:
• two SFP+ 10G interfaces
• one CONSOLE interface
• 50-pin B2B connector interface between iRPD and OIB
• 1 DS X 2 US Physical RF ports between iRPD and GS7000
General Information
for detailed descriptions of