Honeywell C300 User Manual page 74

4. C300 Controller Configuration
4.10. Create a Control Module
Considerations
All illustrations used in the procedure are for example purposes only.
WARNING
All edits done on project-related objects must be reloaded to the controller
before those edits can be seen in the controller. Refer to the Control
Strategy Loading for information on how to load control strategy objects.
To create and save a Control Module, perform the following steps.
Step
1
Click File > New > Control Module
A blank Control Module is opened up in the Control Drawing area, (shown in
the figure above).
The new Control Module appears under the Unassigned Project Tree. Control
Module names are sequentially numbered (for example, CM_30, CM_31,and
so on).
The new Control Module is automatically saved to your hard drive.
Select Edit > Module Properties... or double-click inside the chart to open
2
the Control Module parameter configuration form for input.
70
Action
Series 8 C300 Controller User's Guide
Honeywell
R500
April 2017