Nozzle Mount; No Probe Option; Table 5: Slg720 Recommended Nozzle Dimensions; Table 6: Probe Diameters - Honeywell SLG 700 Quick Start Manual

Nozzle mount

The transmitter can be mounted to a tank nozzle using the appropriate flange.
See Figure 9 for an example. Table 5 shows recommended nozzle dimensions based on
probe type.

Table 5: SLG720 recommended nozzle dimensions

Recommended nozzle
diameter (D)
Minimum nozzle
diameter (D)
Recommended nozzle
height (H)
(*) When using a flexible probe in nozzles taller than 6" (150 mm) the SWB wire
probe with extension stud is recommended. SWB or PWB are options in the
model selection guide. These offer a 300 mm rod extension to keep the selection
of the wire probe that is in the nozzle, from moving.
Note: The Blocking Zone is an area on the transmitter where no measurements
are performed.

No probe option

The guided wave radar transmitter is available with a no probe option where
the transmitter is supplied with a nut and lock washer without a probe.
Table 6 provides recommendations for probe diameters and materials of
construction.
Model Thread
SLG720 M5x0.8
M10x1.5
SLG726
December 2017
Single probe
(rod/wire)
6" (150 mm)
2" (50 mm)
4" (100 mm) + nozzle
diameter (*)

Table 6: Probe Diameters

Probe Recommended
type probe diameter
Rod 8 mm
Wire 4 mm
Rod 16 mm
Wire 4 mm
Quick Start Installation Guide
Coaxial probe
> probe diameter
> probe diameter
N/A
Recommended
probe material
ASTM A-276, Type
316L, condition A, or
ASTM B574 alloy UNS
N10276 solution
annealed.
ANSI T316
ASTM A-276, Type
316L, condition A
ANSI T316 (7x7
construction)
25