Honeywell SLG 700 Quick Start Manual page 36

Basic Configuration sub-menu (continued)
4-20 mA
Output (HART
only)
Set LRV
(HART only)
Install Date
Advanced Configuration sub-menu
Mounting
Note: Loop must
be removed from
Automatic
Control
Backgrnd
Capture
(Measured Prod
not Saturated
Steam)
Probe
Note: Loop must
be removed from
Automatic
Control.
Probe Length Cal
(SingleLiqLowDC
Measured Prod
only)
36
LRV
URV
Damping
NAMUR Output
Loop Curr Mode
Latching Mode
BDH/BDL Loop
Set LRV
Set URV
Year
Month
Day
Install Date
Write Date
Transmtr Model (R)
Sensor Conn Type (R)
Proc Conn Type (R)
Mounting Loc
Mounting Angle (Visible for Tank, Bracket or Nozzle mounting
location only)
Nozzle Height (Nozzle Mounting Loc only)
Nozzle Dia (Nozzle Mounting Loc only)
Bypass Dia (Bypass Mounting Loc only)
Stillwell Dia (Stillwell Mounting Loc only)
Backgrnd Type
Dynm Bkgd Updt (Field and Obstacle Backgrnd Type only)
Full Tank Det
Backgrnd Type
Use Level (Obstacle Backgrnd Type only)
Start Capture (capture process is inactive)
Cancel Capture (capture process is active)
Probe Type
Probe Length
Probe End Type
CenterDiskType
CenterDisk Dia (Center Disk Type is not None)
PropagtnFactor
Block Dist Hi
Block Dist Low
SteamRefPrbTyp (Saturated Steam Measured Prod only)
Steam Ref Len (Saturated Steam Measured Prod only)
Start Cal (calibration process is inactive)
Stop Cal (calibration process is active)
Quick Start Installation Guide
SmartLine Level Guided Wave Radar
Decemeber 2017