Wire Probe Assembly; Figure 4: Wire Probe Assembly - Honeywell SLG 700 Quick Start Manual

Wire probe assembly

Step
Fully thread the nut onto the central conductor. Using a lock
washer, thread the wire swage on to the central conductor.
Torque the nut against probe and lock washer to secure the
connection.
1
Note: Tighten the wire stud and nut to the following torque:
If applicable, insert wire probe into end weight. Tighten the 3 set
screws to secure end weight to wire probe
2
Note: Torque set screws to 6 Nm (4.4 ft-lbs)
Note: For flanged SLG726 models, ensure the nut does not intrude into the
bore of the process connector. See
December 2017
 SLG720 6.0 Nm (4.4 ft-lbs)
SLG726 15 Nm (11 ft-lbs)

Figure 3

Figure 4: Wire probe assembly

Quick Start Installation Guide
Action
for more information.
7