Device Setting Setup And Configuration; Figure 4.32 Iserver Mail Notifier Device Setting - Omega iServer Microserver User Manual

4.14.3 Device Setting and Configuration
Device setup requires:
• Entering the IP address for iServer device (for example 192.168.1.200).
• Specifying Socket number (1000 or 2000 depending on iServer settings).
• Defining RS485 Unit # interface address (1 to 199). Enter "0" for RS232 interface
or for iServer.
• Entering Reading command. Normally set to SRT to obtain reading from the
devices.If you want to change this setting, refer to HTTPget Section 4.9.
• Defining the Alarm setup (High/Low, High value, or Low value).
• Specifying Pause Interval. It determines how many seconds each subsequential alarm
notification will be sent.
• Determining Monitor interval. It establishes the interval or time resolution in seconds
for which readings will be obtained from the device.
Alarm Editor
Device Info (1 of 2)
Server IP Address
Socket Number
Bus Address/Device ID
Description
Src ID
Reading Cmd
Alarm Configuration
Alarm Type
Alarm High
Alarm Low
Dev 2
Alarm High
73
0

Figure 4.32 iServer Mail Notifier Device Setting

192.168.1.200
2000
1000
3
1
Dev1
zRdgA
SRTF
Info Message
Email Interval
Monitor Interval
Alarm Hold Time 0.0
56
OK
Cancel
Help
Add Del
Only Monitor Access
to iServer device
0.05 hrs.
0.5 min.
min.