Table of Contents
Advertisement
4.7.5 Terminal / Remote (Tunneling) Server Setup
Figure 4.19 Terminal / Remote (Tunneling) Server Setup
4.7.5.1 TCP/UDP*:
The iServer supports TCP and UDP protocols (default is TCP). If UDP is selected, it can
be configured either for Broadcast UDP or Directed UDP. In case of Broadcast UDP, the
iServer will transmit the data to every node on the network. This can be accomplished if
the Remote IP Address is set to 255.255.255.255.
The Broadcast UDP is a practical solution when one iServer needs to communicate with
multiple nodes over the network. In the case of directed UDP, the iServer will transmit
the data to a specific node on the network. This can be accomplished if the Remote IP
Address is set to the IP address of that specific node.
4.7.5.2 Server Type:
Continuous mode sends all current measurement input values and update the graphic
chart to Ethernet, continuously, every one second. It is mainly used to send readings to a
remote display.
Command mode needs a command to query the iServer to get the response back to the
querying device. However all details of measurement are still updating including the
chart.
4.7.5.3 Number of Connections:
The range is from 0 to 5.
If 0 is selected, the Terminal Server feature is disabled.
1-5 (TCP mode) can allow the number of querying device to receive the response from
the iServer
If 1 is selected, only one network connection can be made to the device 's Ethernet port.
Any number more than 1 would allow the network hosts to monitor (read only) the traffic
on the device 's Ethernet port simultaneously, but only one network host would be
allowed to read and write (default is 5).
TCP
TCP/UPD
Server Type
Number of Connections
Port
2000
Remote Access
Remote Port
2000
Remote IP Address
0.0.0.0
Continuous
5
disable
Save
41
Advertisement
Table of Contents
