Batch Mode - Omega iServer Microserver User Manual

4.7.1.3 Batch Mode

This mode is for either single or dual input counting and monitoring visually number of
definable batches that is required by users' application. To setup Batch value (unit count)
and Batch mode, users must access Configuration Page for detail of setting descriptive
parameters. However users should notice the following important items on Chart:
SP1 must be also understood as actual A Batch (unit count) value.
SP2 must be also understood as actual B Batch (unit count) value.
Batch A must be understood as Number of Batches counted via CH A.
Batch B must be understood as Number of Batches counted via CH B.
For Example: Machine A requires oil drop lubrication every 3199 PCB's produced then
there must be done 89 times for 1 hour and Machine B requires a soft-reset every 12000
PCB's produced then there must be done 28 times for 1 hour as Figure 4.11 illustrates. If
Time Scale Option of 1 Minute (1 Sec/Div.) is selected, Users can monitor process,
tracking time and be prepared for the required tasks in precise timely manner.
With the Example:
h=Machine A maintenance requirement: A Batch (unit count) value= 3199 PCB's
i=Machine B system requirement: B Batch (unit count) value= 12000 PCB's
j= Number of Batches (or lubrication) counted via CH A input= 89 times
k= Number of Batches (or soft-reset) counted via CH B input= 28 times
Make certain that Debounce Time must be zero when operating with
frequency signals.
26