Table of Contents
Advertisement
4.7.2.6 SP2 Value
Enter desired value for Alarm2 Setpoint or B Batch and its factory default value is 0.
Whatever number is entered for modifying The SP2 Value or B Batch will be displayed in
exponential format after SAVE button is pressed or clicked.
4.7.2.7 SP2 Latch Mode
Select either "Unlatch" (as default option) for unlatched Alarm2 operation or "Latch" for
latched Alarm2 operation.
4.7.2.8 SP2 Active Mode
Set device alarm activation Above (as default option) or Below SetPoint 2 value.
4.7.2.9 SP2 Dead Band
Enter desired value of Alarm2 Dead Band.
4.7.2.10 SP2 Active Status
Select the logic normal-state of Alarm2 Output and its factory default value is High.
For Alarm Status Monitoring or indicators, refer to Chart's Items Description.
Any above settings must be saved for taking effect by its designated SAVE
button, which is localized in this section, before returning to Chart.
4.7.3 Title Definability Utility
This section of Configuration Page allows users define or name the desired Name of
Task/Experiment, Unit of Measure of application and Title of Chart and the space limits
as following:
Name: has max.16 characters
Unit of Measure: has max.16 characters
Title: has max.16 characters
Figure 4.17 Example of Title Definability Utility Section
Any above settings must be saved for taking effect by its designated SAVE
button which is localized in this section before returning to Chart.
Name
Rate Monitor
Unit of Measure
R&D Engr.Lab
Title
HZ
Save
37
Advertisement
Table of Contents
