Xcommand Systemunit Adminpassword Set; Xcommand Systemunit Configurationprofile Cancelchange; Xcommand Systemunit Configurationprofile Change; Xcommand Systemunit Configurationprofile List - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction
Standby commands
xCommand Standby Activate
Set the system in standby mode, which turns off the video outputs and put the camera into sleep
mode.
Requires user role: USER
Example:
xCommand Standby Activate
xCommand Standby Deactivate
Bring the system out of standby mode.
Requires user role: USER
Example:
xCommand Standby Deactivate
xCommand Standby ResetTimer
Set a temporary standby delay (in minutes). If the system is in standby mode when the reset timer
is set, the system is brought out of standby mode. When left idle for the given delay the system
goes into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid standby
delay.
Requires user role: USER
Parameters:
Delay(r): <1..480>
Example:
xCommand Standby ResetTimer Delay:10
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration
SystemUnit commands

xCommand SystemUnit AdminPassword Set

xCommand SystemUnit ConfigurationProfile CancelChange

xCommand SystemUnit ConfigurationProfile Change

xCommand SystemUnit ConfigurationProfile List

119
xCommand xCommand
Set a password for the user that is currently signed in.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 64>
Example:
xCommand SystemUnit AdminPassword Set Password:***********
Cancel the "ConfigurationProfile Change" command, that would otherwise take effect after next
system boot.
Requires user role: ADMIN
Example:
xCommand SystemUnit ConfigurationProfile CancelChange
Select a previously saved configuration profile. NOTE: Requires a restart of the codec.
Requires user role: ADMIN
Parameters:
Name(r): <S: 0, 255>
Example:
xCommand SystemUnit ConfigurationProfile Change Name: "My _
ConfigurationProfile _ 1"
*r ConfigurationProfileChangeResult (status=OK):
Warning: New configuration profile will be active after next boot.
** end
List configuration profiles that has been stored in the system.
Requires user role: ADMIN
Example:
xCommand SystemUnit ConfigurationProfile List
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.