Cisco TelePresence SX20 Codec Reference Manual page 64

Cisco TelePresence SX20 Codec
Contents Introduction
xConfiguration SIP Profile [1..1] TlsVerify
For TLS connections a SIP CA-list can be uploaded to the video system. This can be done from the
web interface.
Requires user role: ADMIN
Value space: <Off/On>
Off: Set to Off to allow TLS connections without verifying them. The TLS connections are allowed
to be set up without verifying the x.509 certificate received from the server against the local CA-
list. This should typically be selected if no SIP CA-list has been uploaded.
On: Set to On to verify TLS connections. Only TLS connections to servers, whose x.509 certificate
is validated against the CA-list, will be allowed.
Example: xConfiguration SIP Profile 1 TlsVerify: Off
xConfiguration SIP Profile [1..1] Outbound
Turn on or off the client initiated connections mechanism for firewall traversal, connection reuse and
redundancy. The current version supports RFC 5626.
Requires user role: ADMIN
Value space: <Off/On>
Off: Connect to the single proxy configured first in Proxy Address list.
On: Set up multiple outbound connections to servers in the Proxy Address list. A random proxy is
selected from the list for each SIP outbound request.
Example: xConfiguration SIP Profile 1 Outbound: Off
xConfiguration SIP Profile [1..1] Proxy [1..4] Address
The Proxy Address is the manually configured address for the outbound proxy. The default port is
5060 for TCP and UDP but another one can be provided.
If SIP Profile Outbound is enabled, multiple proxies can be addressed.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: If SIP Profile Outbound is enabled, use a fully qualified domain name. If SIP Profile
Outbound is disabled, you can also use a valid IPv4 address or IPv6 address.
Example: xConfiguration SIP Profile 1 Proxy 1 Address: ""
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration xConfiguration
xConfiguration SIP Profile [1..1] Proxy [1..4] Discovery
xConfiguration SIP Profile [1..1] Type
xConfiguration SIP Profile [1..1] Mailbox
64
xCommand
Select if the SIP Proxy address is to be obtained manually or by using Dynamic Host Configuration
Protocol (DHCP).
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: When Auto is selected, the SIP Proxy address is obtained using Dynamic Host Configuration
Protocol (DHCP).
Manual: When Manual is selected, the manually configured SIP Proxy address will be used.
Example: xConfiguration SIP Profile 1 Proxy 1 Discovery: Manual
Enables SIP extensions and special behavior for a vendor or provider.
NOTE: The SIP types Alcatel, Avaya, Microsoft, and Nortel are no longer supported from software
version TC6.3.
Requires user role: ADMIN
Value space: <Standard/Cisco>
Standard: Use this when registering to standard SIP Proxy (tested with Cisco TelePresence VCS
and Broadsoft)
Cisco: Use this when registering to Cisco Unified Communication Manager.
Example: xConfiguration SIP Profile 1 Type: Standard
When registered to a Cisco Unified Communications Manager (CUCM) you may be offered the
option of having a private voice mailbox. Enter the number (address) of the mailbox in this setting, or
leave the string empty if you do not have a voice mailbox.
Requires user role: ADMIN
Value space: <S: 0, 255>>
Format: String with a maximum of 255 characters.
Example: xConfiguration SIP Profile 1 Mailbox: "12345678"
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.