Audio Configuration; Xconfiguration Audio Defaultvolume; Xconfiguration Audio Soundsandalerts Ringtone; Xconfiguration Audio Soundsandalerts Ringvolume - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

Audio configuration

xConfiguration Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch
on or restart the video system. Use the Touch controller to change the volume while the video
system is running. You may also use API commands (xCommand Audio Volume) to change the
volume while the video system is running, and to reset to default value.
Requires user role: USER
Default value: 50
USAGE:
xConfiguration Audio DefaultVolume:
where
DefaultVolume
: Integer (0..100)
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

xConfiguration Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: USER
Default value: Sunrise
USAGE:
xConfiguration Audio SoundsAndAlerts RingTone:
where
RingTone
: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xConfiguration
DefaultVolume
RingTone
xCommand

xConfiguration Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: USER
Default value: 30
USAGE:
xConfiguration Audio SoundsAndAlerts RingVolume:
where
RingVolume
: Integer (0..100)
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.

xConfiguration Audio Input HDMI [n] Level

This setting applies to HDMI [2..3] for single camera systems, and to HDMI [3] for dual camera
systems.
Define the audio level of the HDMI input connector, in steps of 1 dB.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Audio Input HDMI
where
Level
: Integer (-24..0)
Select a value between -24 and 0, in steps of 1 dB.
36
API Reference Guide
xStatus Appendices
RingVolume
n Level: Level
Copyright © 2016 Cisco Systems, Inc. All rights reserved.