Tuning Rip - Cisco Nexus 7000 Series Configuration Manual

Chapter 12 Configuring RIP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
Command
Step 9
vrf member vrf-name
Example:
switch(config-if)# vrf member
RemoteOfficeVRF
Step 10
ip address ip-prefix/length
Example:
switch(config-if)# ip address
192.0.2.1/16
Step 11
ip router rip instance-tag
Example:
switch(config-if)# ip router rip
Enterprise
Step 12
show ip rip [instance i nstance-tag ]
interface [ interface-type slot/port ]
[vrf vrf-name ]
Example:
switch(config-if)# show ip rip
Enterprise ethernet 1/2
Step 13
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
The following example shows how to create a VRF and add an interface to the VRF:
switch# config t
switch(config)# vrf context RemoteOfficeVRF
switch(config-vrf)# exit
switch(config)# router rip Enterprise
switch(config-router)# vrf RemoteOfficeVRF
switch(config-router-vrf)# address-family ipv4 unicast
switch(config-router-vrf-af)# redistribute eigrp 201 route-map RIPmap
switch(config-router-vrf-af)# interface ethernet 1/2
switch(config-if)# vrf member RemoteOfficeVRF
switch(config-if)# ip address 192.0.2.1/16
switch(config-if)# ip router rip Enterprise
switch(config-if)# copy running-config startup-config

Tuning RIP

You can tune RIP to match your network requirements. RIP uses several timers that determine the
frequency of routing updates, the length of time before a route becomes invalid, and other parameters.
You can adjust these timers to tune routing protocol performance to better suit your internetwork needs.
You must configure the same values for the RIP timers on all RIP-enabled routers in your network.
Note
OL-20002-02
Purpose
Adds this interface to a VRF.
Configures an IP address for this interface. You must
do this step after you assign this interface to a VRF.
Associates this interface with a RIP instance.
(Optional) Displays RIP information for an interface.
in a VRF.
(Optional) Saves this configuration change.
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Configuring RIP
12-15