Rip Example Configuration; Related Topics; Default Settings; Additional References - Cisco Nexus 7000 Series Configuration Manual

RIP Example Configuration

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
RIP Example Configuration
This example creates the Enterprise RIP instance in a VRF and adds Ethernet interface 1/2 to this RIP
instance. The example also configures authentication for Ethernet interface 1/2 and redistributes EIGRP
into this RIP domain.
vrf context NewVRF
!
feature rip
router rip Enterprise
vrf NewVRF
address-family ip unicast
!
interface ethernet 1/2
vrf NewVRF
ip address 192.0.2.1/16
ip router rip Enterprise
ip rip authentication mode md5
ip rip authentication keychain RIPKey

Related Topics

See

Default Settings

Table 12-1
Table 12-1
Parameters
Maximum paths for load balancing
RIP feature
Split horizon

Additional References

For additional information related to implementing RIP, see the following sections:
•
•
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
12-18
redistribute eigrp 201 route-map RIPmap
max-paths 10
Chapter 16, "Configuring Route Policy Manager"
lists the default settings for RIP parameters.
Default RIP Parameters
Related Documents, page 12-19
Standards, page 12-19
for more information on route maps.
Default
8
Disabled
Enabled
Chapter 12 Configuring RIP
OL-20002-02