Configuring Ipv4 Addressing - Cisco Nexus 7000 Series Configuration Manual

Chapter 2 Configuring IPv4
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.

Configuring IPv4 Addressing

You can assign a primary IP address for a network interface.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command
Step 1
config t
Example:
switch# config t
switch(config)#
Step 2
interface ethernet number
Example:
switch(config)# interface ethernet 2/3
switch(config-if)#
Step 3
ip address ip-address/length
[secondary]
Example:
switch(config-if)# ip address 192.2.1.1
255.0.0.0
OL-20002-02
config t
interface ethernet number
ip address ip-address/length
show ip interface
copy running-config startup-config
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Purpose
Enters configuration mode.
Enters interface configuration mode.
Specifies a primary or secondary IPv4 address for an
interface.
• The network mask can be a four-part dotted
decimal address. For example, 255.0.0.0 indicates
that each bit equal to 1 means the corresponding
address bit belongs to the network address.
The network mask can be indicated as a slash (/)
•
and a number - a prefix length. The prefix length
is a decimal value that indicates how many of the
high-order contiguous bits of the address
comprise the prefix (the network portion of the
address). A slash must precede the decimal value
and there is no space between the IP address and
the slash.
Configuring IPv4
2-7