Verifying Hsrp Configuration; Hsrp Example Configuration - Cisco Nexus 7000 Series Configuration Manual

Chapter 19 Configuring HSRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
HSRP extended hold timers are not applied if you configure millisecond HSRP hello and hold timers.
Note
To configure HSRP extended hold timers, use the following command in global configuration mode:
Command
hsrp timers extended-hold [ timer ]
Example:
switch(config)# hsrp timers extended-hold
Use the show hsrp command or the show running-config hsrp command to display the extended hold
time.

Verifying HSRP Configuration

To verify HSRP configuration information, use one of the following commands:
Command
show hsrp [group group-number]
show hsrp delay [interface interface-type
slot/port]
show hsrp [interface interface-type slot/port]
show hsrp [group group-number] [interface
interface-type slot/port] [active] [all] [init]
[learn] [listen] [speak] [standby]
show hsrp [group group-number] [interface
interface-type slot/port] active] [all] [init]
[learn] [listen] [speak] [standby] brief

HSRP Example Configuration

The following example shows how to enable HSRP on an interface with MD5 authentication and
interface tracking:
key chain hsrp-keys
key 0
key-string 7 zqdest
accept-lifetime 00:00:00 Jun 01 2008 23:59:59 Sep 12 2008
send-lifetime 00:00:00 Jun 01 2008 23:59:59 Aug 12 2008
key 1
key-string 7 uaeqdyito
accept-lifetime 00:00:00 Aug 12 2008 23:59:59 Dec 12 2008
OL-20002-02
Purpose
Sets the HSRP extended hold timer, in seconds.
The timer range is from 10 to 255. The default is
10.
Purpose
Displays the HSRP status for all groups or one
group.
Displays the HSRP delay value for all interfaces
or one interface.
Displays the HSRP status for an interface.
Displays the HSRP status for a group or interface
for virtual forwarders in the active, init, learn,
listen, or standby state. Use the all keyword to see
all states, including disabled.
Displays a brief summary of the HSRP status for
a group or interface for virtual forwarders in the
active, init, learn, listen, or standby state. Use the
all keyword to see all states, including disabled.
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Verifying HSRP Configuration
19-17