Cisco Nexus 7000 Series Configuration Manual page 152

Configuring Advanced OSPFv2
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
See the
interval and dead timer.
BEFORE YOU BEGIN
Ensure that you have enabled the OSPF feature (see the
page
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
DETAILED STEPS
Command
Step 1
config t
Example:
switch# config t
switch(config)#
Step 2
router ospf instance-tag
Example:
switch(config)# router ospf 201
switch(config-router)#
Step 3
timers lsa-arrival msec
Example:
switch(config-router)# timers
lsa-arrival 2000
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
6-38
"Configuring Networks in OSPFv2" section on page 6-17
6-14).
config t
router ospf instance-tag
timers lsa-arrival msec
timers lsa-group-pacing seconds
timers throttle lsa start-time hold-interval max-time
timers throttle spf delay-time hold-time
interface type slot/port
ip ospf hello-interval seconds
ip ospf dead-interval seconds
ip ospf retransmit-interval seconds
ip ospf transmit-delay seconds
show ip ospf
copy running-config startup-config
for information about the hello
"Enabling the OSPFv2 Feature" section on
Purpose
Enters configuration mode.
Creates a new OSPFv2 instance with the configured
instance tag.
Sets the LSA arrival time in milliseconds. The range is
from 10 to 600000. The default is 1000 milliseconds.
Chapter 6 Configuring OSPFv2
OL-20002-02