Chapter 2
Configuring IPv4
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
Command
Step 3
ip proxy-arp
Example:
switch(config-if)# ip proxy-arp
Step 4
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
This example shows how to configure Proxy ARP:
switch# config t
switch(config)# interface ethernet 2/3
switch(config-if)# ip proxy-arp
switch(config-if)# copy running-config startup-config
Configuring Local Proxy ARP
You can configure Local Proxy ARP on the device.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command
Step 1
config t
Step 2
interface ethernet number
Example:
switch(config)# interface ethernet 2/3
switch(config-if)#
OL-20002-02
config t
interface ethernet number
ip local-proxy-arp
copy running-config startup-config
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Purpose
Enables Proxy ARP on the interface.
(Optional) Saves this configuration change.
Purpose
Enters configuration mode.
Enters interface configuration mode.
Configuring IPv4
2-11