Chapter 2
Configuring IPv4
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
Verifying the IPv4 Configuration
To verify configuration information, use the following commands:
Command
show hardware forwarding ip verify
show ip adjacency
show ip arp
show ip interface
show ip arp statistics [vrf vrf-name]
IPv4 Example Configuration
This example shows how to configure an IPv4 address:
config t
interface e 1/2
no switchport
ip address 192.2.1.1/16
Default Settings
Table 2-1
Table 2-1
Parameters
proxy ARP
Additional References
For additional information related to implementing IP, see the following sections:
•
•
OL-20002-02
lists the default settings for IP parameters.
Default IP Parameters
Related Documents, page 2-16
Standards, page 2-16
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Purpose
Displays the IP packet verification configuration.
Displays the adjacency table.
Displays the ARP table.
Displays IP related interface information.
Displays the ARP statistics.
Default
disabled
Verifying the IPv4 Configuration
2-15