Configuring Rip; Enabling The Rip Feature - Cisco Nexus 7000 Series Configuration Manual

Chapter 12

Configuring RIP

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
•
•
Configuring RIP
This section includes the following topics:
•
•
•
•
•
•
•
•
•
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.

Enabling the RIP Feature

You must enable the RIP feature before you can configure RIP.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
OL-20002-02
Cisco NX-OS does not support RIPv1. If Cisco NX-OS receives a RIPv1 packet, it logs a message
and drops the packet.
Cisco NX-OS does not establish adjacencies with RIPv1 routers.
Enabling the RIP Feature, page 12-5
Creating a RIP Instance, page 12-6
Configuring RIP on an Interface, page 12-8
Configuring a Passive Interface, page 12-10
Configuring Route Summarization, page 12-11
Configuring Route Summarization, page 12-11
Configuring Route Redistribution, page 12-11
Configuring Virtualization, page 12-13
Tuning RIP, page 12-15
config t
feature rip
show feature
copy running-config startup-config
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Configuring RIP
12-5