Load Sharing And Multipath; Route Aggregation - Cisco Nexus 7000 Series Configuration Manual

Nx-os unicast routing configuration
Hide thumbs Also See for Nexus 7000 Series:
Table of Contents

Advertisement

Chapter 11
Configuring Advanced BGP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
The router does not apply a penalty to a resetting BGP peer when route dampening is enabled, even
Note
though the peer reset withdraws the route.

Load Sharing and Multipath

BGP can install multiple equal-cost eBGP or iBGP paths into the routing table to reach the same
destination prefix. Traffic to the destination prefix is then shared across all the installed paths.
The BGP best-path algorithm considers the paths as equal-cost paths if the following attributes are
identical:
BGP selects only one of these multiple paths as the best path and advertises the path to the BGP peers.
Paths received from different AS confederations are considered as equal-cost paths if the external
Note
AS_path values and the other attributes are identical.
Note
When you configure a route reflector for iBGP multipath, and the route reflector advertises the selected
best path to its peers, the next hop for the path is not modified.

Route Aggregation

You can configure aggregate addresses. Route aggregation simplifies route tables by replacing a number
of more specific addresses with an address that represents all the specific addresses. For example, you
can replace these three more specific addresses, 10.1.1.0/24, 10.1.2.0/24, and 10.1.3.0/24 with one
aggregate address, 10.1.0.0/16.
Aggregate prefixes are present in the BGP route table so that fewer routs are advertised.
Cisco NX-OS does not support automatic route aggregation.
Note
Route aggregation can lead to forwarding loops. To avoid this problem, when BGP generates an
advertisement for an aggregate address, it automatically installs a summary discard route for that
aggregate address in the local routing table. BGP sets the administrative distance of the summary discard
to 220 and sets the route type to discard. BGP does not use discard routes for next-hop resolution.
OL-20002-02
Weight
Local preference
AS_path
Origin code
Multi-exit discriminator (MED)
IGP cost to the BGP next hop
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
Information About Advanced BGP
11-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents