Enabling The Policy-Based Routing Feature - Cisco Nexus 7000 Series Configuration Manual

Configuring Policy-Based Routing
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.

Enabling the Policy-based Routing Feature

You must enable the policy-based routing feature before you can configure a route policy.
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command
Step 1
config t
Example:
switch# config t
switch(config)#
Step 2
feature pbr
Example:
switch(config)# feature pbr
Step 3
show feature
Example:
switch(config)# show feature
Step 4
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Use the no feature pbr command to disable the policy-based routing feature and remove all associated
configuration.
Command
no feature pbr
Example:
switch(config)# no feature pbr
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
17-4
config t
feature pbr
show feature
copy running-config startup-config
Chapter 17
Purpose
Enters configuration mode.
Enables the policy-based routing feature.
(Optional) Displays enabled and disabled features.
(Optional) Saves this configuration change.
Purpose
Disables the policy-based routing feature and
removes all associated configuration.
Configuring Policy-Based Routing
OL-20002-02